1999 Mitsubishi Mirage 1, guides for the operation of 8 L engine. In support of the Assembly of the engine during the removal and installation of the transaxle. scan tool (MUT-11). Contact the instrument scan (MUT-11) of the diagnosis connector. Turn key to "to" and select "Belt tension measurements on screen menu. Hold the microphone until the middle of the belt of the device between the wheels (in the place indicated by the arrow) around 10-20 mm (0.39-0.79 inches) from the back of the belt and so it is perpendicular to the belt (within angle of k15 ). Gently press in the middle of the belt between pulleys (place indicated by the arrow) with the Earth, as shown in the illustration. Verify that the frequency of oscillation of the belt is within the standard value. Account 1. The temperature of the surface of the belt must be close to normal temperature. 2. shall not allow any contaminants such as water or oil, to get into the microphone. 3. If the strong gusts of wind blow against the microphone, or if there is any source of noise nearby, the measured values of the microphone may not match the actual values. 4. If the microphone touches the belt at the time of measurement, the measured values of the microphone may not match the actual values. 5. do not take measurements while running the engine of the vehicle. Use belt tension gauge to check whether the belt tension is within the range of the standard value. checking the ignition time 111001 701 50 before the inspection, set the vehicle in the following condition: 0 engine coolant temperature: 80-95 ° C (1, 76-203 mm F) 0 lights, electric cooling fan and all the Accessories: OFF 0 Transaxle: neutral (P range of vehicles with A/T) of the scan tool for connecting through the data link connector. Set the time light. Start the engine and run when idle. Verify that the move was in approximately 700 rlmin. Select "point of no. 17 of the actuator test tool scan. Check whether the main illumination is within the standard value. Fixed value: they BTDC k 3 "If main switch is outside the standard value, check the MFIS components by reference to the Group 13 a-troubleshooting. Press to clear the instrument scan (select the activation of force cancel mode) and deleted the test of the actuator. Note If it has not been repealed, force-activation persists for 27 minutes. Driving the vehicle in this condition, or engine may be corrupted. 10. verification of the actual limit of illumination is the standard value. Fixed value: approximately they BTDC Note 1. Ignition is variable within for + cylinder, even under normal operation. 2 time is automatically extended by approximately from 5 mm BTDC at a higher altitude.
Download: 1999 Mitsubishi Mirage 1, guides for the operation of 8 L engine
0 comments:
Post a Comment